CT03 Hydraulic pipe cutting machine

首页 > Products > Hydraulic equipment > Hydraulic pipe cutting machine > CT03

CT03 Hydraulic pipe cutting machine

Composition of the cutting machine:
The cutting machine is mainly composed of cylinder, oil-water separator, speed regulating knob, pneumatic pressing device foot switch,
Electrical master switch, built-in round knife, ABB motor, Israel belt drive, round knife shaft,
Consisting of a pair of NSK housings and a chip collection box.
Technical Parameters:
1. Rated cutting maximum diameter: 1 1/2" i.e. DN38mm four-layer steel wire wound pipe
2. Motor power: 4KW
3. Original imported German round knife: 350 x 3 x 50mm or 400 x 4 x 30mm
Domestic high-quality material round knife: 350 x 3 x 50mm or 400 x 4 x 30mm
Domestic general material round knife: 400 x 2.8 x 32mm
4. The speed of the saw blade: 2900rpm
5. Working voltage: 380V/50Hz
6. Minimum air pressure: 6bar
7. Pressing speed: adjustable
8. Dimensions: 940 x 570 x 1420 mm

产品详细PDF下载

筛选依据：

1: Cylinder and pneumatic depression device: The pneumatic depressing device driven by the cylinder presses down the hose,

so that the round knife in the box can cut the hose smoothly, so that the rear end of the hose cutting is smooth and not skewed.

2: Speed control knob: adjust the speed of the cylinder pressing device, so that when cutting the hose assembly, according to the diameter of the hose, the speed of the cylinder pressure is appropriately selected.
3: Foot switch: The foot switch is to control the up and down reciprocating movement of the piston rod of the cylinder.
4: Oil-water separator: The pressure of the control system, the minimum air pressure in use is 6bar.

English

Product Categories

Application

Solution

Knowledge

About

Brand Story

CT03 Hydraulic pipe cutting machine